[. . . ] Operating Guide for RTS-DataPak-C and RTS-DataPak-C/S Circuit-Switched Data Transmission over CDMA Networks 1. [. . . ] If a serial unit is used (RTS-DataPak-C/S), depressing SW2 a 3 rd time displays the baud rate, typically 9, 600 baud. If a modem unit is used, depressing SW2 a third time will turn the display off. Use a PC or laptop (8 N 1 and 9, 600 baud) to connect to the DB9 setup port of the RTS-DataPak. After several messages indicate progress of programming, OTA PROGRAMMING SUCCESSFUL !Type STATUS to display programmed MIN, dial PHONE number, device baud rate (for serial units), RSSI, temperature, and battery voltage (if applicable). If MIN and PHONE numbers are different, type program to enter PHONE number. Obtain operating status by calling the RTS-DataPak from a PSTN-based PC or laptop equipped with a modem via a communications program such as HyperTerminal. The reply will indicate RSSI, temperature, battery voltage, and identify the modem or serial version of the RTS-DataPak. [. . . ] See Technical Support at www. transtelgroup. com. I503282 Page 1 of 1 [. . . ]